Remote Control User Manual of Solar Street Light

Remote control user manual：

Use UVA technology, remote distance can reach 30M, three lighting modes for choose, can direct penetration of obstacles and according sunshine of each season to adjust。

The most suitable mode can be selected according to seasonal sunshine conditions.

Model A: Time Control Mode

3 hours 100% Brightness => 3 hours 80%

Brightness => 4 hours 40% Brightness => 2

hours 100% Brightness.

Model B: PIR Induction Control Mode

3 hours When Human Sensing 100% Brightness, otherwise 90% => 3 hours When Human Sensing 100% Brightness, otherwise 80%       => 4 hours When Human Sensing 70% Brightness, otherwise 20%     => 2 hours When Human Sensing 100% Brightness, otherwise 80%.

Model C: Time Control Mode

3 hours 100% Brightness => 3 hours 70%

Brightness => 4 hours 40% Brightness => 2

hours 90% Brightness=> 3 hours 100% Brightness.

The remote controller is powered by two 1.5V No. 7 batteries. It can switch the LED lamp and write parameters to the controller with one key.

Remote control switch: when the remote control is turned off, press this key once, the remote control will be turned on and the indicator light will be on. When the remote controller is turned on, press and hold this key for 4- 5 seconds, and then release it. The remote controller is turned off and the indicator light is off.

Light On: Turn on the LED lamp: when the lamp is off, the remote controller is aimed at the transmitter and receiver of the controller, and press this key once, and the LED lamp is on.

Light Off: Turn off the LED lamp: when the lamp lamp is on, the remote controller is aimed at the transmitter and receiver of the controller. Press this button once, and the LED lamp turns off.

Mode A: write a complete set of lighting modes and save them to the remote controller. Align the remote controller with the transmitter and receiver of the controller. Press this key once to write the lighting mode into the controller.

Mode B: write a complete set of lighting modes and save them to the remote controller. Align the remote controller with the transmitter and receiver of the controller. Press this key once to write the lighting mode into the controller.

Mode C: write a complete set of lighting modes and save them to the remote controller. Align the remote controller with the transmitter and receiver of the controller. Press this key once to write the lighting mode into the controller.